I doubt it would hurt a thing provided there is no twist on the frame.


"mac davis" wrote in message
...
I don't think this is a critical question, but it does sort of worry me...

Does anyone know of a downside for the lathe to have one end of the
stand/table
higher than the other?

My Jet mini usually sits level on the stand, but if I'm hollowing
something,
especially if it's small and deep, I've been putting a 4x4 under the tail
stock
end of the lathe so this ol' back bends less...

Could this hurt the lathe?

Maybe put a side load on the bearings or something?



mac

Please remove splinters before emailing