You don't really need to cut the top off the tank to fill it with sand.
There should be 4 2" fittings on the top, remove all the pipes and fill it
through the fittings. Use clean dry sand and it won't take that long. I
don't know where your located, but if the tank is a homeowner tank, no one
really keeps track of them. Just fill it with sand, and if your worried
about some one using it, cap it with concrete.
gary


"davefr" wrote in message
...
I buried a 500 gallon gas tank in the late '70's for farm use. I used
it for about 10 years and then pumped it dry.

Complete removal is impractical since a small shed is built on top of
it and I don't want to demolish the shed.

I'd really like to cut the top off and fill it with rock or dirt so
it's decommisioned once and for all.

I checked with the state DEQ office and they told me 500 gallon tanks
are unregulated. My only obligation is to report a spill but this
tank never leaked since I quit using it very early in it's life.

I'm not too fond of the idea of using a cutting torch. Even though
it's totally dry there could still be fumes and I don't want to get
dead. For the same reason, I really don't want to use an angle
grinder.

I'm thinking sawsall or pneumatic chisel.

Anyone know how underground tanks are decomisioned? I'd like to
remove a 5' X 2' portion of it's top.

Is there a safe way to make 100% sure the tank is vented such as
injecting an inert gas that's heavier then gasoline fumes to drive
them out?

Other suggestions?