Afternoon all,

I need to round over the edge of a piece of 3/4" ROak with a 9" dia.

Is there an easy and safe way to do this on a router table. I could place a
pin
(bolt) in the router table about 2" from the bit and use it as a guide, but,
not sure if
that's a good idea or not. Any thoughts on this method?

Or is it better to secure it to a larger piece of wood and use a handheld
router?
Problem here is 'hiding' the holes on the top (good) side.
Would carpet tape hold it in place well enough?

Any suggestions would be appreciated,
Ron