On Wed, 09 Mar 2005 21:13:30 +0000, [news] wrote:

Jonathan Telfer wrote:
Evening all,
I have a mixer tap which leaks at the junction between tap body and
swing arm. I took the arm off and found an o ring which needs
replacing. It is square in section, ~18 mm internal diameter, 22mm
external, 3mm deep. Plumb centres to DIY stores etc all draw blanks.
Where does everyone get their o rings from?

Thanks

Jon

I'll wager it's a round one, squeezed into a square groove

http://supaseal.co.uk/products.htm

via

http://tinyurl.com/5h3ms

hth


RT
Thanks for the link. I'm fairly sure it started life with a squared
section. It's flat on both internal and external edges + when I showed it
to the plumb centre people they remarked on it being square section.