just as a side note, whenever i have to get into something, i write the
breaker number on the inside of the plate. makes it easy later.

randy

"xrongor" wrote in message
...
seems wise nonetheless...

randy

"Bud" wrote in message
...
No need for a warning (assuming NEC).

Bud--


gary wrote:
Rewiring an old house to put more plug ins etc. Fishing wire down the
walls to the basement. Now I have a bunch of wires I want to put on a
few circuits. I want to run wires from breakers to a large junction
box, then tie the wires together in there that will go to each circuit.
As long as I don't go over the boxes rating for wires, can more than one
circuit be served by one box? Or should I have a separate box for each
circuit?

I did a net search for this and only found one post where a fellow said
it was ok if you put a warning on the box cover that it is served by
more than one breaker.

I want this to be to code.

TIA
Gary