Scroll's are in almost all equipment nowadays, with the exception of the
Climatuf.

--
Bob Pietrangelo


www.comfort-solution.biz
On Time or Your Service Call is FREE
Preventive Maintenance Specialist




"Robert11" wrote in message
...
Hi,

Thanks for all the good advice.

Let me show my ignorance: "Personally when I change units again I will
make
damn sure that I get a
scroll compressor."

What's a scroll compressor ?
Why is it better ?
More expensive ?

Found on what mfg's units, etc. ?

Thanks again,
Bob
--------------------

"SQLit" wrote in message
news:uwpVd.147300$0u.119643@fed1read04...

"Robert11" wrote in message
...
Hello:

Will be looking to replace a 30 yr old gas, forced hot air heating
furnace
in a residence.

Read Consumers Research, and they "rate" American Standard as best,
with
Rheem next.

Am always a bit leery with CR's ratings, as they seldom really go into
the
methodology they use.

Anyway, there is such good advice on this forum, thought I'd ask here.

Is it the general consensous of you folks that American Standard (and
then
Rheem) really are the
two top brands to consider for gas, forced hot air furnaces ?

Why ?

Any to "absolutely" avoid ?

Might as well also ask: same manufacturer rating order for the split
type
of A/C where the condenser is
placed outside the house ?

Thanks,
B.

The manufacture is not the most important part. The installer is.

Check out the seer and heat ratings for all of the units your going to
consider. Narrow it down to 4-5 models and then seek contractors. Make
sure
that they do calculations. Not just "you got a 2 ton so we will replace
it
with a 2 ton." Have them inspect your duct work and see if there are any
challenges that need to be corrected.

Check the guarantees and do not forget to call your utilities. They
might
have rebates if you buy a certain level of equipment.

Personally when I change units again I will make damn sure that I get a
scroll compressor.