Well maybe when you unplugged it the connection to the prong that plugs into
the cord broke. Being internal it would look ok on the outside. Like the
other guys said, voltmeter time. Turn the saw on and check for continuity to
ground on each prong.
"pray4surf" wrote in message
news
Craftsman - Model 137.248830 - 3.0 HP

Not the best (by a long shot) But mine...

Used it today to rip and crosscut (with sled)... Finished up a crosscut,
turned the switch off. Once blade stopped spinning, removed the work and
the sled.

Unplugged from power supply to use the CMS... Went back a little later,
plugged the unit back into the power supply, flipped the switch...
Nothing.
Test power supply, other tools run fine....