View Single Post
  #3   Report Post  
robo hippy
 
Posts: n/a
Default




George,
After 7 years of selling bowls, I have come to the conclusion that
there is no standard that will sell all of the time. Some people like
shallower bowls, some like deeper bowls. Some like them thin, some like
them thick, some like dark, some like light. If you are going to a
show, in order to do $ 3,000 sales, you need $6,000 to $10,000 worth of
inventory, of all sizes and shapes, bowls, boxes, rolling pins,
spheres, vases, etc. Specialization is for insects.
robo hippy



















Leif Thorvaldson wrote:
"George" george@least wrote in message
...
In between setting up the crockpot with stew for tonight's dinner

and
serving lunch to my temporarily invalided spouse, I turned a hard

maple
bowl
this morning. It was one of those "tweeners," small for salad,

marginal
for
a bag of micro popcorn, and too big for a nut bowl. I figure most

likely
use is chips or such, so I consciously did a few things for my

customer.

1) I cut the walls thin, for capacity, but left the bottom heavy

for
stability.
No sense making something tippy if it's going to be picked up and

set down
multiple times in use.

2) I made a lip outside and a slight undercut inside, where a thumb

can
find
a grip as the bowl is passed.
No sense making something easy to drop and spread the contents on

the
dogs'
"table."

3) I prepped it for a surface finish - probably polyurethane -

rather than
a
show only type. No sense leaving it too vulnerable to water if

folks are
going to have to wipe out the fragments of chips and/or oil with a

bit of
detergent and water.

Now it's plain vanilla, as hard maple tends, but I consider that

its
utility
enhancements make it the useful equal of a piece of curly fluff

that can
barely stand on its own and sports a buffed wax finish over a

French
polish.

What considerations do you folks give your customers when you

approach a
blank?



=== George, I note that you are having dilemma after dilemma when

the
answers are right at hand. Just make sure it meets all OSHA, FDA,

NIH, NTSB
standards and your problem is solved. I am sure somewhere in the

bowels of
Government there are standards for a non-standard-sized potential
chip/popcorn bowl. You seem to be skirting proper thinking in these
matters! *G*

Leif