On Wed, 02 Mar 2005 22:25:40 -0600, "B.B."
u wrote:

For class I'm turning an aluminum flywheel. 3" diameter. The steps
a face the sides, drill & ream the center, press onto a mandrel, turn
the outside and sides. Anyway, after pressing it onto the mandrel (yes,
I cleaned out the cutting oil) I've found that I have to go very slowly
or the cutting tool will grab the wheel and spin it on the mandrel.
What are some good ways to deal with this problem? I already crammed
it as far onto the mandrel as I'm comfortable with. I'm tempted to just
loctite the damn thing.

Superglue works quite well as long as you dont have any tool chatter.
So does regular fingernail polish.

I make my own mandrels by turning a rod to diameter, drilling and
tapping the end, then slitting with a hacksaw or slitting saw. Slip
over the workpiece, then installing a socket head cap screw in the
tapped hole to expand as needed.

Best if done in a collet of course. but works fine in a three jaw if
you dont remove it during any of the process.

Cheap and easy to make, grabs well.

Gunner


Lathe Dementia. Recognized as one of the major sub-strains of the
all-consuming virus, Packratitis. Usual symptoms easily recognized
and normally is contracted for life. Can be very contagious.
michael