Standard biscuit is 4mm. .1574"

"GerryG" wrote in message
...
Hmmm...maybe a bad run of blades? That's sounds like the most likely
cause.

Used to have the specs on this...no matter.
My DeWalt blade measures 0.157 on a tooth, and a cut slot measures the
same.
From 1/2 dozen biscuits, I'm seeing 0.157-0.160.
GerryG

On Tue, 01 Mar 2005 14:52:18 -0600, Dan Oelke wrote:


I picked up my PC 557 this weekend (should have done it through Amazon,
but didn't plan far enough in advance.... sigh)

I also noticed the same thing about sloppy fit. I was able to align my
board edges (mostly) when I had the clamps put on with very light
pressure, and then finished tightening.

So - now I'm curious - what should the biscuit thickness and slot
thickness be? (I'll get out the dial calipers tonight....)

Dan