"Dennis Thompson" wrote in message
...


Mike Henry wrote:

I'll gladly buy one, but no one seems to make Morse Taper 2 end mill
holders
for 3/4" shanks any more. Someone (the VersaMill guy?) once offered to
make
a few specials in that size but ISTR that he needed to get around $200
each
in small quantities just to break even. That's a bit over my tool
budget.



Mike,

You can order one from JTS Machinery in Ohio for $20.00, and take 10%
off every
Tuesday for a final cost of $18.00. The part number is MT2-34, their
phone
number is (800) 321-3566. I'm picking up an MT-3 end mill holder for a
1"
shank, they are the only source for them also. Be sure and get their
catalog.

Thanks - that's just what I did. They are out of stock, but this is has
been a long-standing need so waiting a little longer is not an issue.

Mike