"PrecisionMachinisT" wrote in message
...

"Mike Henry" wrote in message
...

I'll gladly buy one, but no one seems to make Morse Taper 2 end mill
holders
for 3/4" shanks any more.



Nobody makes 4 inch dia x 1/2 in shank silver & deming drills either, go
figure....

I gather that you think a 3/4" end mill holder will put too much torque on
the MT2 spindle. My primary application would be for occassional fly
cutting of aluminum with a 3" insert fly cutter with modest DOC. Is that
too much to expect?.