"jim rozen" wrote in message
...
In article , Harold and Susan Vordos says...

Granted in between the two, he did compare you to cliff.

While I'm possibly fanning the flames by posting, I have only one thing to
add.

I was not comparing Harold to Cliff. I thought they should discuss (again,
the literal meaning of my words) this matter as Cliff (if my memory serves)
has previously stated that centerless grinders do not make round parts.

Of course, with Cliff he might talking a couple of millionths of an inch,
but that's besides the point.

The only comparison between Cliff and Harold is that they both (seem) to
have great knowledge and experience in their respective fields. These fields
happen to be at the opposite ends of the manufacturing spectrum, however.

Regards,

Robin