Thanks Peter

In message , Peter Taylor
writes

Snip

1. Do the felts go under the whole valley (with
boards and lead on top?
2. Do the felts go between the lead and boards?
3. Do the felts go just up to the gravel boards with the lead overlapping
it by, say 80 mm?
I have also been advised to lay an extra triangular piece of board
along the length of the valley to give it a flat bottom rather than leave
it as a "V" shape. Any comments welcome.

Valley tiles are vulnerable to leaks because they are actually at a lower pitch
than the main roof slope. The lead sheet should be on the bottom, directly on
the valley boards, and anything else, such as the sarking felt under the tiles,
should be dressed over it, not under as you suggest.
OK
The lead should be about
500mm wide in min Code 4 thickness and in lengths not exceeding 1.5m with
150-200mm overlaps.
My pamphlet says minimum Code 5 for pitched valleys (British Lead Mills,
probably to sell more lead!).
It also gives minimum overlaps from 85 to 290mm depending upon Pitch
(from 15 to 85 degrees)
It should be fixed only at the top of each length and 500mm
OK TA
down each side from the top, otherwise expansion and contraction will cause
splits. The two long edges of the lead should be welted and turned up over
preserved softwood battens or ideally triangular fillets about 200mm apart,
The fillets shown are a minimum 150mm from centre of valley but about
200mm across centre to centre of triangular filets.
My diagram shows the edges welted over by about 15mm, but a local
roofer told me it was not necessary, but I think he was just lazy!
to
prevent water run-off and to support the edge of the tiles. There is no
need for
the valley to have a flat bottom board.
OK but I had thought it may have provided a wide slower trickle rather
than a narrow fast gush washing over the top of the ninety degree gutter
corner!
The cut tiles should overhang the
fillets by about 38mm so there is about 125mm between the cut edges,
OK TA (my drawing shows about 75mm min overhang with an additional clear
channel of 25mm behind cement filet (this did seem a lot to me).
and the
sarking felt should be trimmed along the bottom edge of the tiling.
All the cut
tiles should be nailed and bedded in mortar, but be sure to keep the mortar off
the lead as this will cause corrosion.
OK, tile "slips" are quoted but have been advised felt is also OK.

Have you looked at using a preformed GRP valley liner? A lot cheaper and
easier.

Someone did recommend I had a look at some in Travis Perkins, which is
what I will do, but I do not know of their durability (and how well
they will finish at the bottom).

Peter

Thanks again for the information.
--
Peter Hemmings