In article ,
"Upscale" wrote:

"Robatoy" wrote in message news:design-
Leon suggested I'd take a look at the Triton.
I did. At the Chatham Woodworking Show, two Sundays ago, I had a chance
to fondle it. Some great features. I just love the 'Bob The Builder'

If this router was upside down in a router table, and can be height adjusted
from above, how fine an adjustment can be done? With most of the router
lifts, really fine height adjustment can be used to sneak up on an exact
cut. In your opinion, could this router accomplish the same thing as easily?

Thanks



If your question is about the Triton, Leon would be the man to ask.
If the question is about the Milwaukees..I'd say yes. (After you twist
out the 'slop' and pre-load the adjuster. 0.1 mm or so.)