The thickness is approximately 1 inch between the faces of the heatsinks. I
haven't tried pulling it apart yet as my friend is trying to get specs on
it. I'll post whatever info I get.
Thanks
Karl

"Bob May" wrote in message
...
I'd doubt the 1" thickness as Peltier modules are a lot thinner than that
normally. Even the xy directions are a bit dubious as the largest
normally
are in the inch and a half size. You may have some axuilary parts put
onto
the module to help get the heat moved about.
You get to pump about 180BTU of heat with a single module for the most
part
and anything as big as you are discussing should be able to handle about 4
times that if the size of the actual device is that big.

--
Why isn't there an Ozone Hole at the NORTH Pole?