Grant wrote:
I'm just curious. What is the process you go through when you change your
14" bandsaw blade (Delta, Jet, Grizzly, etc) ? And especially when you go
from one type/size to another. Also how long does it take you to make the
changes needed?
Thanks, Grant


On my Delta 14":

1.) Remove power

2.) Back off the guides

3.) Pull the table pin

4.) Drop the tension

5.) Open the doors and change the blade, rotating by hand to check
tracking after adding a touch of tension.

6.) Add tension until blade sings proper pitch

7.) Adjust the guides

8.) Replace the table pin

9.) Verify my 90 degree table stop

10.) Fire 'er up

11.) Make a quickie test cut and fine tune tension, etc...


I can usually do this in under 5 minutes, often along the lines of 3.
It probably took longer to write it. I use Cool Blocks running right
against the blade, so guide adjustment is a snap. After a few run
throughs, adjusting the rear guide becomes an eyeball affair.

Once my wheels were made coplanar, and the first heavy duty tune-up was
completed, blade changes are a snap.

If only I can get the hang of folding blades. G

Barry