Hey Grant,

Hmmmm.. I hate to argue, but I've got three lathes, and two of them
have a jog button. In fact, at the moment, I have a fourth here for
"repair", and it has a jog button also.

Take care.

Brian Lawson,
Bothwell, Ontario.
XXXXXXXXXXXXXX
On Mon, 31 Jan 2005 07:53:18 -0800, Grant Erwin
wrote:

wrote:

I just bought a Birmingham 12x36 gearhead lathe. Installed a 220v outlet in
the garage. Plugged it in and looked for the power start button. the manual
said there was one, but I could not find it. The only power button I could
find is the jog/inch button. That button just jogs the lathe. If I hold it
down it continues to run but I can't imagine that Birmingham had intended
the operator to hold the jog button down to turn parts. There is a red
reset button but that just breaks the circuit and shuts things off. There
is a green power light that looks like a button but it is just a light. It
can't be pushed. Were the heck is the button that lets the lathe run
continually without being held down???? The manual is very unclear and
amateur....Birmingham needs to hire a technical writer.

Kimball

Maybe they wired in the wrong switch on your machine? The one that should
have been on/off is instead jog/inch? Normally there isn't a jog/inch switch
on a lathe! - GWE