$3.87 at McMaster.com part number 7881K17

Greg O wrote:
"Rex" wrote in message
.net...

I have an antique hobby lathe (ca 1930s Craftsman Companion??) that uses
belts and pulleys to drive the leadscrew. The pulleys are vee'd, and about
1/4" across the top of the vee. Overal length of the belt is 16 inches,
maybe 16.25" at the outside/top of groove. Where can I get two belts?
I think the urethane round belts would work fine as well. MSC shows
them in "make your own" but the minimum quantity is too high.
This lathe sits on a display shelf and probably won't be ever used,
but I'd like to complete it.


If it will never get used, how about a 1/4" "O" ring about 5" diameter?
also, McMaster Carr stocks 2L belts, 1/4" wide.
Greg