On Sun, 30 Jan 2005 17:03:47 GMT, Rex
wrote:

I have an antique hobby lathe (ca 1930s Craftsman Companion??) that uses
belts and pulleys to drive the leadscrew. The pulleys are vee'd, and
about 1/4" across the top of the vee. Overal length of the belt is 16
inches, maybe 16.25" at the outside/top of groove. Where can I get two
belts?
I think the urethane round belts would work fine as well. MSC shows
them in "make your own" but the minimum quantity is too high.
This lathe sits on a display shelf and probably won't be ever used,
but I'd like to complete it.

Check your local Ace Hardware. They often keep a good selection of
those smaller belts.
Of course any bearing or belt house will have them.

Gunner

"Considering the events of recent years,
the world has a long way to go to regain
its credibility and reputation with the US."
unknown