On Sun, 30 Jan 2005 17:03:47 GMT, Rex wrote:

I have an antique hobby lathe (ca 1930s Craftsman Companion??) that uses
belts and pulleys to drive the leadscrew. The pulleys are vee'd, and
about 1/4" across the top of the vee. Overal length of the belt is 16
inches, maybe 16.25" at the outside/top of groove. Where can I get two
belts?
I think the urethane round belts would work fine as well. MSC shows
them in "make your own" but the minimum quantity is too high.
This lathe sits on a display shelf and probably won't be ever used,
but I'd like to complete it.

I once slit a belt sander sanding belt to repair an antique drill press. It
worked surprisingly well



Regards,

Boris Mohar

Got Knock? - see:
Viatrack Printed Circuit Designs (among other things) http://www.viatrack.ca

void _-void-_ in the obvious place