Steve, perhaps a nitpicky answer, but there is a little more to setting
a drill in a drill (Jacobs) chuck than seating its Morse tapered arbor
in the lathe spindle. Rotate the drill bit as you close the jaws on the
shaft, not the twists. Tighten at each keyhole around the chuck as you
close the jaws. Make sure the workpiece is centered. Make a small entry
hole with a center bit, tip of a skew or small gouge to start out right.


Turn to Safety, Arch
Fortiter



http://community.webtv.net/almcc/MacsMusings