In article , John wrote:
Lawrence Wasserman wrote:
The 3/4 X 3/8 bar stock is a little difficult to find, but a home
center like Home Depot or a good hardware store will usually stock 3/4
X 1/4 which I find works just as well.
And you can buy a 3 foot piece for a lot less money than a commercial
miter bar.

I wonder, though, about the tolerances. The Incra miter bars are machined
straight to pretty tight tolerance. How close to straight is the bar stock at
Home Cheapo?

--
Regards,
Doug Miller (alphageek-at-milmac-dot-com)

Get a copy of my NEW AND IMPROVED TrollFilter for NewsProxy/Nfilter
by sending email to autoresponder at filterinfo-at-milmac-dot-com
You must use your REAL email address to get a response.