On Sun, 23 Jan 2005 00:27:48 GMT, "habbi"
wrote:

of years ago. The blades are level with the outfeed table but I find
anything I put through it does not touch the blades for the last 1/4. The
first 3/4 of the stock get jointed but then the cutters do not touch the
work for the rest of the pass. What is going on here? Thanks

You might check the tables to be sure they are in line with each
other. Turn the spindle so your blades don't contact a long straight
edge placed across both tables. Raise the in feed table to the same
height as the out feed table and see if the straight edge will lay
flat across and along both tables. If it does not you can remove the
tables and clean any debris from the surfaces where there is contact.
This should get the tables back in a straight line.


Mike O.