On 22 Jan 2005 09:06:50 -0800, "mcare1" wrote:
This could have been a nice easy fault
It still might be! ;-)
not in the psu,
Ok ..
but there is a metal heat sink down the centre of the pcb,
I remember seeing a lasgish one .. I think it was bent though 90 deg?
resolder all
of the parts of this only 2 or 3 transistor and a frame ic , normally
dry joint on these parts
I think I did de/re-solder those .. I could check again .. ?
if you resoldered the psu just maybe a case of replacing the chopper
transistor and or ic
Ok, I'll see what I can spot. It *was* only a primary run-over, a
first pass so to speak.
good luck
Thanks fella .. ;-)
All the best ..
T i m
|