Sorry, got Maarten's name wrong. My apologies!

"Andy" skrev i meddelandet
...
Now, I have hooked up the scope to the base of the scope and found no
pulse train on startup exept one transient burst that seems like startup
noise. However, on shutdown there is a square wave for a fraction of a
second. This is accompanied with a sharp "click" in the speaker and
discharge "tweet" from the power supply area. To be more precise, that
"tweet" is actually a frequency sweep starting at around 1 kHz and
increasing.

Martin Bakker suggested that it could be the TDA3576 that has broken. I
will start searching for a datasheet for that device. Or does anybody know
on which pin the output is?

Thanks a lot for your help!

Andy

"Andy" skrev i meddelandet
...
Thank you for your time, Jerry.

I will hook up the scope tomorrow and let you know the result.

Andy

"Jerry G." skrev i meddelandet
...
If you put a scope on the base of the HOT, do you get the startup pulse
train? If so, this means that the kick start for the scans and power
supply
should normally be okay.

There is a chance that there is a scan or HV fault, and it is going in
to
the protect mode. In many sets, when they do this type of fault, I have
found them to have defective capacitors, and or a defective flyback
transformer. It is also possible at the same time to have some other
failed
components as well.

--

Jerry G.
=====

"Andy" wrote in message
...
My old (20 years) faithful Philips TV-set died last day, and I have
tried to
find the cause, without success. As far as I know, I think it is in the
startup circuits.

What do I know?

-Chassis: 26CS5779/13Z
-Death: Just died while watching
-Fuses: checked OK

Symptoms:

-No high tension.
-Faint hiss in speaker
-Responds to remote control but channel indicator dead.
-13V and 190V test points on board have no voltage.
-140V collector-emitter voltage on flyback transistor. No base voltage.
Unsoldered and checked OK.
-Most transistors tested by using diode test. 0.7v drop. =ok
-Diodes checked OK.

Any clues as where to look?
thanks a bunch!

Andy