Alan Bierbaum wrote:

Take the fence and rails off. Remove the top with wings attached. Remove
the motor. Two people can handle the parts. Watch out for shims or spacers
under the bolts holding the top to the cabinet (if there, they need to go
back in the same places).
....

If you have people, can get by w/o the whole top--just the fence, wings
and motor are enough. Then, use some blocking for an intermediate point
and set the bottom on the truck first. The table then gives a good
handhold to rotate it up. Two of use did it w/ mine...

Isn't there any dock at the shop at all, though?