In article t, RoyJ says...

Sounds like your brush has a 5x10 pattern. How about an aplicator that
has 5 nozzels, pull the trigger 10 times and you are done. Perhaps 60 to
100 pieces per hour. Preheating the brush to 150 to 200 degrees would
help flowout for either the solvent or hot melt glues.

Mmmm. A five-wide hot-melt glue gun applicator. Tricky
but it could be done. Feed one glue stick into a heated
chamber with five outlets, each one with a small heater
on it to keep the temp up near the outlets.

Jim


--
==================================================
please reply to:
JRR(zero) at pkmfgvm4 (dot) vnet (dot) ibm (dot) com
==================================================