Thanks TOM!!!!!

I never thought about the dishwasher. I have a junction box mounted
behind the dishwasher where I can get power from... Will do that and will be
much easier...BTW... I have a florescent light above the sink that shares
it's power from a kitchen countertop receptacle. I know that because as I
was flipping breakers I lost the florescent light and that receptacle at the
same time.
Thanks again...Jim



"HorneTD" wrote in message
ink.net...
Jim M wrote:
Hello,

I want to install a Garburator (food disposer) in our Kitchen. The
problem I am having is routing the power wire. I have a 110 volt plug
above the kitchen counter under the kitchen cabnets aproximately 5 feet
away from the sink where I want to get the 110 volt power to energize the
disposer. I obviously have studs in the way if I were to route the wire
straight across inside the wall and don't want to remud walls etc....
Since the kitchen cabnets are over the plug AND where I want to
put the switch. I am considering routing the wire directly up inside the
wall and poke the wire out directly above the cabnets, then run the wire
down the cabnet to the stud where the switch will be.....then poke the
wire back inside the wall and fish down to the new switch box where I
will mount the switch. Running a wire on top of the cabnets will be
totally invisible unless your 8 feet tall......The rest is easy...just
run the wire down and come in under the sink.

My question is: Is this common practice? Or is this a Hokey fix?
Thanks....Jim

It is a violation of the electrical code in most places to use the
circuits that supply counter top receptacles to supply any other load. It
is not a violation to power both a dishwasher and the food waste disposer
from the same circuit but you may not be able to run both at once.
--
Tom H