wrote in message
...
The holes are round. They're reamed. I need to be in the center +/- .002.
This makes a lot of sense. I knew I was missing something.

Thanks guys!

Ron, I don't know how far you have to move off the hole, but if you're
trying to hold +/- .002 inches, I presume you've also verified your DRO's
are accurate?

I only bring this up because of self professed "inexperience".

Is this the way it's normally done? This takes me a long time
(inexperienced)
The only instructions I've found on line, tell me how to locate a straight
edge.


I also agree with Harold in a post further down. Use a DTI and sweep the
hole.