Thread
:
Hole center with an edge finder??
View Single Post
#
2
Tim Wescott
Posts: n/a
wrote:
I'm locating the center of some holes .500" dia with a Starrett edge finder.
The tip of the edge finder is .200. I'm just not sure if I'm doing it the
BEST way.
Maybe I'm missing something. Basically, I lower the tip of the edge finder
just inside
the hole. I then move the X axis until It touches. I then move the Y axis
until it's
not touching. Then back to the X until it touches. I keep this up until
rocking the Y axis
no longer provides any clearance. Then I move the X in .150 and zero the
DRO.
Then I repeat this process again for the Y axis. Basically, I'm finding the
tangent of the 2 axis.
Is this the way it's normally done? This takes me a long time
(inexperienced)
The only instructions I've found on line, tell me how to locate a straight
edge.
Any PRO suggestions appreciated.
RonL
I'm not a pro machinist, but I do math for a living. Try this:
Get the edge finder in the hole. Move X until it touches and note the
DRO reading. Now move X the other way until it touches and note the DRO
reading. The average of these two values should be X center. Put the
thing at X center and do the same in Y. Double check using your method
if you're not sure.
--
Tim Wescott
Wescott Design Services
http://www.wescottdesign.com
Reply With Quote