DanG wrote:
Place in a vise. Slide pipe over the end that sticks out. Push
or pull as required.

This method can even be set up to be repeatable.

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Keep the whole world singing . . . .
DanG (remove the sevens)




wrote in message
. com...
Lets say I have a small mild steel metal rod... about 1/3" in
diameter.. and
I need to bend it in the middle about 45 degrees. What would be
the easiest
way to do this? Is there any sort of 'bender' commonly
available? Thanks!

-Mike

--
A happy kid behind the wheel of a 98 Mustang GT
Cold air intake
FRPP 3.73 gears
Steeda Tri-Ax Shifter
Flowmaster 40 Series mufflers (self-installed woohoo)
Hi-speed fan switch
255/60R-15 rear tires
Subframe connectors
Aluminum adjustable clutch quadrant





Or . . . . for a sharper bend, whang it with a sledge hammer.
Bugs