Thread
:
Need to bend a small metal rod
View Single Post
#
3
DanG
Posts: n/a
Place in a vise. Slide pipe over the end that sticks out. Push
or pull as required.
This method can even be set up to be repeatable.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Keep the whole world singing . . . .
DanG (remove the sevens)
wrote in message
. com...
Lets say I have a small mild steel metal rod... about 1/3" in
diameter.. and
I need to bend it in the middle about 45 degrees. What would be
the easiest
way to do this? Is there any sort of 'bender' commonly
available? Thanks!
-Mike
--
A happy kid behind the wheel of a 98 Mustang GT
Cold air intake
FRPP 3.73 gears
Steeda Tri-Ax Shifter
Flowmaster 40 Series mufflers (self-installed woohoo)
Hi-speed fan switch
255/60R-15 rear tires
Subframe connectors
Aluminum adjustable clutch quadrant
Reply With Quote