Afternoon All,

Here is a little update on the doors and drawer fronts for my parents
kitchen,

An awkward cut, raising the end of a very long narrow panel. Used a roller
stand.

http://www.federatedtool.com/david/img/panel1.jpg

Rasing the rest of the panels wwas much easier, expecially with the help of
a power feeder,

http://www.federatedtool.com/david/img/panel2.jpg

I made two jigs for the cope cuts, one for each end of the rails. I just
made the jig, I had been free handing copes with a push block for the last 5
years, this is *much* nicer,

http://www.federatedtool.com/david/img/cope1.jpg

I never thought a door could look so pretty, but here is a single door that
is supposed to look like two. It will be the front for the pull out pantry,
I took 10 different photos, but none really turned out to show just how nice
the door looks. There is a 3/8" wide, 3/16" deep dado in the centre of the
middle rail to divide the doors.

http://www.federatedtool.com/david/img/bigdoor.jpg

http://www.federatedtool.com/david/img/bigdoordone.jpg

A couple of drawer fronts in clamps. Notice the one odd door, that is the
front for the lazy susan (full height of undercounter cabinet). I will run a
dado from side to side in it to make it look like a seperate drawer front
and cupboard door.

http://www.federatedtool.com/david/img/dfs.jpg

Now for the other bazzilion panels I have to make...

David.

Every neighbourhood has one, in mine, I'm him.