"James "Cubby" Culbertson" wrote in message ...
Thanks Barry. I will have to drill through the cast iron wing to mount the
table.
I was a little concerned the stress put on the wing might be too much
without inboard legs.
Sounds like that's not a concern. I'm wiring up 220V today and will start
putting the rest
of the saw together tonight maybe.
Cheers,
cc

My Jet contractor saw came with iron wings and a short extension on the right side. The whole thing is supported across the back of the the saw with 1.5" angle iron. The front also has angle iron running the entire width to support the fence rail. All of these surface have stayed as flush as the day I put them together.

The only modification I made was some fancy legs on the outside edge of the extension table made with leftover 2x4s and lag bolts for levelers. This was necessary because I 'accidentally' leaned on the extension table and the saw almost fell over.