"NSM" writes:

"Sam Goldwasser" wrote in message
...

| Sorry if I missed where in their catalog it might be. They have the
| Vishey multiturn assemblies but I don't see knobs sold separately. This
is not
| just some common knob for a 1/4" shaft. It snaps onto a large outer shaft
| that has set screws to permit the relationship of the dial and pot or
| whatever is being turned, to be calibrated.

I assumed you'd replace the whole assembly. Hard to imagine you could buy
parts for this these days.

Let's see.... Cost of new assembly: $20+S&H. Cost of knob? It's probably
available because I'm probably not the first one to have come across a
device without it. There is nothing wrong the thing, that knob is desiged
to snap off so the calibration can be adjusted.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.