Thread
:
You guys were right!! (was "gear motor powering VS bandsaw")
View Single Post
#
2
Ned Simmons
Posts: n/a
In article . com,
says...
Well, I wired up the gearmotor and controller tonight to try it before
I went any further. You guys were right. Not enough torque, I tried
cutting 1/4" HR flat stock and it came to a stop, would probably cut
1/8", to aggrivated to try. Anyone want to make me an offer on a Leeson
motor with KB controller???
Did you turn up the torque limit and install the proper HP resistor in
the KB controller? Is it a KBIC?
Ned Simmons
Reply With Quote