"majortom" writes:

Don't have any past experience with yours, but could be caused by the
Servo Output IC. Chase the cables that lead from the drive to the main
board, I'm sure the Servo IC will stick out like a sore thumb from
there. Also check in that vicinity for signs of resistors that may have
changed color, most likely not obvious with the naked eye, best to
check them for tolerance. They should be resistors in the circuit
between the IC and the motor itself.

More likely cause is that the spindle motor is partially shorted. See:

http://repairfaq.ece.drexel.edu/sam/cdfaq.htm#cdpwspmm

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.