Rik Powe wrote:
Which method of making Frame and Panel "Shaker" style doors is more
error free and easier for a semi-newbie? (Router or table saw)

The cabinet doors will have a veneer panel. The stiles and rails can
be cut with either a (a) tongue and groove router bit set or (b) be
done on the table saw with use of a tenoning jig and dado.

About 20-25 doors to make.

I ask as I am choosing which equiptment to buy...(already have a good
table saw, but may need to replace my Craftsman crap router). Both
options seem to be about the same price...


Thanks,

Ted

I just got finished making 7 cherry doors for kitchen cabs I am
building. My stock is 3/4". I used a 1/4" slot cutting bit in a
router table for the rails and stiles. Set in the middle for the
stiles and run through on both sides to center. And then set low for
the rails. I used a sled to guide the rails and made sure that I had
backers for all operations. I did not have chip out problems.

The convenience for this is that once the fence is set correctly, you
know that you will get exactly the same depth of cut for all
operations. Just be careful when cutting for the stiles. Be sure to
use test pieces and sneak up on the right height adjustment or the fit
will be too loose. Also make sure that your stock is uniform
thickness.

I probably would have experimented with the table saw, but I don't have
a blade with flat top teeth and already had a slot cutting bit for the
router. I found the router to be easy and accurate using featherboards
when slotting the stiles and a sled to cut the rails.

~ Wyatt