You might want to upgrade the drill bit. Woodcraft has a line of good
bits that are available in 64/ sizes. Good luck 15-2 15-4 and a run for 7


J.B. Bobbitt wrote:

I know it sounds pretty easy: get a nice board, drill the holes, play
cribbage. But I got problems.

I'm making two boards for my daughters (we've played since they could count
and add; they're teenagers now), so they've got to be perfect. So I got a
verrrrrrry nice board (see separate post for "ancient kauri wood"). I also
bought the continuous track cribbage template from Rockler, which spec's
using a Vix bit for the holes. I've taken the Wreck's advice,
test/practice before you f*** it up. Most cribbage boards/pegs use
"standard" 1/8" or 9/64" holes.

Problems:

1. The Vix bit (No. 9, 9/64") doesn't make a clean hole (in other scrap; I
have no scrap of the good board). The peg holes are closely spaced (0.20"
on center); there's enough tearout between holes to discourage me from using
it. I can't find a 9/64" brad point bit. Pluswhich, the Vix bit housing
spins enough to counter sink the plexiglass template enough to make me worry
about using the template too many times.

2. I'm not keen on drilling hundreds of holes with a 1/8" brad point bit
without a template. (I don't like the template I got anyway, but that's my
fault. I'd prefer to use a 4-track pattern, e.g. Dreuke CribbageMaster).

3. I had planned on finishing the boards with shellac before I drilled the
holes, but the tearout problem has me re-thinking that. But, I don't like
the prospect of finishing the boards after drilling the peg holes, because
the shellac will fill the holes (I'm pretty sure it will, anyhow), and I'd
have to re-drill the holes afterwards, again without a template.

OK, any or you Wreckers made cribbage boards out of wood you're reluctant to
screw up? Any insight? Or flames?

As always, thanks a heap.
-jbb