Hello there,

BTW -- is this pic reversed ?
http://www.federatedtool.com/david/img/runthrough.jpg

On my router table I feed from left to right facing the cutter -- againts
the rotation of the blade. This pic either shows already milled material
heading back into the cutter or the whole operation is backwards from they
way I would have done it. Inquiring minds.....

Nope, it is a fake shot. I didn't want to take the time to take a pic when I
was really doing the cutting, so I took a fake shot when I was done with the
equipment off, I cheated!

I think I will try climb cutting into the cutter today. The powerfeeder
wheels have 3/4" of sprung travel and provide lots of downforce, enough I
think to allow climb cutting.

David.