Of course I may have not understood the question but here is how I
would do it. And have done it! We put a 1/4 keyway in a 1" diameter
shaft 20' long using this method.
http://newenglandmodelengineeringsoc...nload_page.htm
At the top of the list click on "Sliding Vise Trick".
Errol Groff
Instructor, Machine Tool Department
H.H. Ellis Technical High School
643 Upper Maple Street
Dantieson, CT 06239
New England Model Engineering Society
http://newenglandmodelengineeringsociety.org/
On 29 Dec 2004 22:05:01 -0800, "Miki" wrote:
I tried searching, but couldn't seem to come up with the correct search
term. I'm quite sure this has been discussed though.
If you have a tube with a hole drilled in it radially, and want to
drill more holes exactly in-line with the existing hole, how would you
do this on a drill press? Finding the center of the tube is the easy
part, but how do you know you have the tube "clocked" correctly on the
V-block?