Thread
:
Need to figure out angle
View Single Post
#
17
Lew Hodgett
Posts: n/a
writes:
I need to figure out the taper angle on a piece of wood. Can someone
help me out?? The piece is 18 7/16" long. The top is 1 11/16" wide and
the bottom is 2 3/16" wide. What angle would I need to cut that?
IMHO, you can't get there from here by trying to adjust some cutting tool to
an angle guide.
Suggest the following:
1) Lay out the angle with a straight edge and a pencil.
2) Trim away any waste in excess of about 1/4"-1/2".
3) Clamp on a straight edge and clean up with a router and a pattern or
bottom bearing, trim bit.
(I do it both ways)
HTH
Lew
Reply With Quote