"Roger Shoaf" wrote:


"Bruno" wrote in message
.. .


Later, when I slit the first one with a hacksaw, I found that the
.025" slit was not quite enough to tighten it to the tool post.


So there you go, just hack saw a little bit more. In the alternative, use a
Dremel with an abrasive wheel. With a wide enough slot, you can wrap a
piece of wet and dry sand paper around your shaft rough side out and lap off
the tooling marks inside the clamp.

How do I hacksaw another 20 thou? I got the dremel out, but the wheel
I have is not big enough radius to get through the slot.

-Bruno