In article ,
says...
I was trying to put a 1.125" hole through a piece of steel that's 1.5"
x 2.5" x 1". I was using a mill and the only 1 1/8" cutter that the
shop I was in had. It made a really lousy rough cut that's also about
.012" oversized. This piece needs to be split to clamp down tight on a
1 1/8" post.

Anyone have a suggestion for how to fix it up?



Saw a number of dead end radial slots out from the ID somewhat like on
adjustable thread gages...

http://www.auto-met.com/gsgage/image...ThreadRing.jpg

This'll allow the ID conform more closely to the diameter of the pin as
the clamp is tightened.

Ned Simmons