How many do you need and what size and thread size and I can make them on my
mill in about two minutes. Contact me off line and just pay the postage.
Dick

--
Richard H. Neighbors
Building fine pool cues for real pool players at affordable prices.
Over 35 years experience in cue repair.
318 Linden st.
Cinti. OH 45216
ph# 513 233-7499
web site: http//www.dickiecues.com
"igor" wrote in message
...
On 19 Dec 2004 18:13:10 GMT, Dave Hinz wrote:

On Sat, 18 Dec 2004 18:32:41 GMT, igor wrote:
I am looking for a 1/2" or 3/4" threaded steel rod (or a bolt at least
4"
long) that has been cut so that it has two flat sides. Sorta like this:
__
(__)

It allows a nut to be threaded on it normally but the flat sides allow
something to be slid over the rod yet not be able to be spun around the
rod
-- if that thing has a complementary non-round hole. Does this type rod
have a name? Sources? TIA. -- Igor

You need someone with a milling machine and/or a lathe; couple of ways
to do what you want. Are you anywhere near Wisconsin, USA?

Dave Hinz

Unfortunately, nope.