i reinstalled the HOT then tried the 1k resistor on the R G B pins
and nothing happened. measured the voltages of R G B and found 88v
measured G1 and G2 on crt neck board found G2 at 0v but G1 was -23.
G1 continued to drop to 0v. if i switch the monitor off/on i get
voltage at G1(100+volts then it drops back to 0v)
it sounds like the monitor is shutting down after switching on.

(tried the resistor on a working monitor and screen went
blue/red/green, G1 and G2 voltages 273v and -27v)


wrote:
Do you have any high-voltage ?
You should have about 22 to 26KV on a 14"
monitor. If you have high-voltage, take a 1K
resistor and connect one end to ground using
a jumper cable. Touch the other end to the
cathode of one of the color video pins on the
crt socket. The screen should light up with that
color.
Also check the G1 and G1 voltages on the
crt socket. G1 should be about -20 to -60 volts.
G2 should be 300 to 600 volts.
Hope this helps...
John