Or just put a block of wood between the table and the chuck and press the
chuck hard into the wood block.
A good wack will do more good than that will. although if you can't make
room or don't have skill to swing a good soft object at the chuck to set it,
this might work just fine.
Normally, we set our J33 chucks and even with the proper set of wedges, it
takes a good 15 minutes to get them off. ...And two sets of wedges after
they deform. Never had a chuck fall off. Then again, I clean both teh
taper and the inside of teh chuck with acetone first.
--
Regards,
Joe Agro, Jr.
http://www.autodrill.com
http://www.multi-spindle-heads.com
V8013