Thanks. I have those holes also. They are there to allow you to attach the
brackets that hold the rails for the outfeed and left side supports which I
have on mine. I will continue to use the outfeed support for small jobs but
when I need the full outfeed table (I don't have enough room in my shop to
have it set up all the time) I can just remove the rear outfeed support and
use the holes for the table. Since some of those holes are also for the left
side support, I will see if I can find longer bolts so I can hold the table
and the left side support in the same hole. Thanks for taking the time to
make the Ascii art.

Dick
"mare" lid.com wrote in
message
news:1gouy3z.1ek4qft8cn9feN%mare*Remove*All*0f*Thi ...
Dick Snyder wrote:

Thanks. I looked under the rear edge of my saw and the only two bolt
holes
(on the right as you face the rear of the saw) are for the side support.
Is
that what you are referring to?

ASCII art (use non proportional font) follows


============================ - sliding table rail
| o o | |
| o| |
| | | |
| | | |
| |- blade o| | - sliding table
| | | |
| | |
| | |
| | |
============================ - sliding table rail


There are holes at the o positions. At least on my Bosch 4000...


My outfeed table looks something like this

_ _
|_|______________________|_| - legs
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| | (o) metal bracket
| | | | - with holes and
| | (o) bolts
| |
| |
|_ _|
| | (o) (o) | | - short legs
=====|=|=============|=|==== - sliding table rail
| o (o) | | |
| (o) |
| | | |
| | | |
| |- blade o| | - sliding table
| | | |
| | |
| | |
| | |
============================ - sliding table rail

HTH

--
mare