"jakdedert" writes:

Bruno Beam wrote:
My PC crashed last night and I got furious and cut it to pieces with a
chainsaw.Now I'm sorry.

How can I repair it?

A new chain--perhaps a new bar--should have it fixed back up. Be sure to
use the proper gas/oil mixture, and keep the chain properly tensioned. They
tend to stretch a bit with the first few uses.

Especially when cutting through sheet steel and fiberglas-Epoxy PCBs.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.